A dimensional inspection report connects a requirement on the drawing with a measured result. It helps you review specified features of first samples or a production batch. TOS agrees the scope of reporting with you before inspection, so that the report addresses the dimensions relevant to acceptance.
Begin with the approved drawing revision, material condition and measurement stage. A result taken before coating or a finishing operation may answer a different question from a result taken on the delivered part. Identify which state the requirement refers to.
The report can be included with the agreed delivery documentation. Its purpose is dimensional evidence for the inspected features and products. Manufacturing quality control covers the wider inspection process; material certificates and laboratory tests provide different types of evidence.
Identify the drawing number and revision. A numbered or ballooned drawing can connect each report line to the correct feature. Record the nominal requirement and its tolerance or applicable reference. Where datum relationships or geometric requirements matter, discuss a suitable inspection method rather than treating the feature as an isolated size.
A report on selected samples does not demonstrate that every item in the batch was measured. Specify the quantity to inspect, the identification of the parts and whether the scope covers all drawing features or a defined selection. If you require every product to be checked, that requirement must be included in the inspection plan.
Depending on the agreed format, report information can include the part reference, batch or sample identification, characteristic number, requirement, measured value and acceptance result. Discuss the relevant measuring equipment, inspection conditions and how the inspected items remain identifiable. A deviation needs a clear disposition; completing a report is not approval to ship a nonconforming part.
For a first delivery, use the results to review the proposed production execution. If a part is corrected, identify the revision and the results that relate to the corrected sample. For repeat orders, agree whether the same reporting scope remains necessary or whether a different control plan is appropriate.
Dimensions that determine assembly and fit deserve particular attention. For machined parts, state whether measurements apply after final machining and finishing. This prevents a report on an intermediate state from being mistaken for evidence about the delivered product.
No. It records the agreed dimensional checks. It does not by itself demonstrate material properties, weld integrity, load capacity or regulatory conformity. Those requirements need their own evidence where applicable.
Send the drawing and revision, order or part reference, batch quantity, critical characteristics and preferred reporting format. State whether you need first-sample reporting, selected batch checks or inspection of every item. TOS can then align the reporting scope with production, inspection and delivery.
Technical request
Upload a PDF, DWG or STEP/STP file and receive a detailed response about manufacturability, the production route and your request for quotation.