Digital product definition

3D CAD design for manufacturing and assembly

A useful CAD model describes more than the outside shape. It defines the component, its interfaces and how it fits into an assembly. TOS uses 3D CAD design to develop your requirements into a digital product definition that can be reviewed with a manufacturing partner.

We start from the function, available installation space and connections to other parts. Dimensions, material and intended production method are considered together. With SolidWorks, design options can be developed and discussed before production drawings are released.

The agreed deliverable may include a component model, an assembly model and technical drawings. File formats, level of detail, ownership and revision status are established in the assignment. A model alone does not replace a drawing where tolerances, material or finishing requirements need to be specified.

What a production-oriented CAD brief defines

Defined interfaces

Identify mating parts, fixing points and available space.

Assembly context

Review component orientation and access for tools.

Manufacturing input

Discuss the model with the relevant production partner.

Agreed deliverables

Set file formats, drawings and the required detail.

Revision control

Keep model and production drawing aligned.

Define interfaces, assemblies and manufacturing requirements

Begin with the connections the design must respect. Which surfaces locate the part? Where are fasteners placed? What clearance is needed for movement, assembly or service? Existing mating parts, installation drawings and reference samples help establish these boundaries.

For an assembly, identify the components, their orientation and how they are joined. Check access for tools and the sequence in which parts are fitted. TOS connects the digital definition with the planned assembly process, so that an attractive model can also be built and maintained.

The chosen manufacturing route influences the design. Machined components, injection-moulded plastics and extruded profiles each bring their own constraints. We discuss manufacturability with the relevant production partner and bring proposed changes back to you for approval.

Where calculations, simulations or specialist assessments are needed, their scope and acceptance criteria are agreed separately. A visual CAD review is not evidence of load capacity or regulatory compliance.

Design workflow

From requirements to released CAD files

Each stage gives the design a clearer definition: requirements, interfaces, model review, verification and controlled release.

1. Define the brief

Record function, interfaces, environment and required deliverables.

2. Develop the model

Create component geometry within the agreed constraints.

3. Review the assembly

Check connections, clearances and practical mounting access.

4. Verify the design

Agree physical trials or specialist checks where needed.

5. Release the files

Approve the drawing and model as one controlled revision.

Deliverables and revision control

A manufacturing handover needs consistent documents. The 3D model, drawing and bill of materials should refer to the same approved revision. Specify units, material, surface treatment and critical dimensions in the agreed documentation. Discuss native CAD files and neutral exchange formats before work starts.

Separate design review from physical verification. A digital model can help identify interference and access problems. A physical prototype can then answer questions about handling, fit or an assembly sequence. The prototype material and process determine what that trial can demonstrate.

When a design is approved, record the release and how later changes will be authorised. If an existing part needs fewer manufacturing steps or lower production cost, our product optimisation review addresses that specific task. Inspection requirements for finished parts can be linked to dimensional inspection reports.

Can TOS start from a sketch or sample?

A sketch, reference part or existing drawing can form the starting point. The brief must still establish the intended function and the dimensions that are authoritative. Missing requirements are resolved with you before the design is released.

Does a 3D model make the part production-ready?

Not by itself. Manufacturing also needs an agreed material, tolerances, finishing requirements and approval status. We define the necessary drawings and checks to support the specific production route.